Yes, a handheld radio kit is possible! Easily connect to any of our intercom kits to complete an in-car setup. This great option is perfect for those looking to communicate with friends and family ...
Developed for the Nitro Bee Xtreme, the CS-NITRO-HS features a 2-pin connection for audio input and output.The short length scanner cord is perfect for crew chiefs and spotters using the Nitro Bee ...
This cable is used to connect a Nitro Bee to a Crew Chief headset & radio set-up. The L-shaped Stereo plug must plug into the Nitro Bee jack while the straight Mono plug goes to the headset.
Red Low-Gain M101 Dynamic Mic. Impedance: 150 Ω
This is the replacement mic for Rugged Radios headsets and helmet kits.
Selecting the right mic will be important for your communication needs. There...
Cut through the wind noise for crystal clear communications! Our High-Wind Environment Mic Muff will work with all size headset mics, and is perfect for refreshing an old, worn mic muff. Compatibil...
The Honda Talon GMR25 mount provides a simple and clean installation for your GMR25 or ABM25 mobile radio Rugged intercom. Installation is easy! Cut around the edge of the upper compartment in th...
IMSA driver set up with out Radio. Includes 2 pin Rugged or Kenwood radio jumper, and Mono AlphaBud foam ear bud speakers.
Kit Includes:
Car Harness
Velcro Mount Push to Talk
Drivers foam Ear Bud ...
Connect IMSA configured communication wiring to wired Stilo helmets. Simply connect the white plug into your Stilo helmet comms jack, and the black plug into an IMSA style harness and you're ready ...
Having noise interference issues with your intercom? Connect this intercom Audio Filter to your intercom to reduce noise generated through the charging system/power supply.
Alternating current fluc...
Not running an intercom? Simply block off the intercom area in the Rugged Multi Mount with the convenient intercom block off plate. The perfect solution when only running a intercom in a SXS, UTV o...
Talk on your iPhone with the Rugged Radio 5-Pin cell phone cable.
This 5-Pin connection is configured for use with 5-pin headsets.
Features:
Locking connector
Gold plated plug
4' foot straight cab...
With this Headset Sizing Kit, you can adjust your adult 'Over the Head' headset to fit your child's head.
Includes a small sized polished stainless steel headband and small foam ear seals.
Your kid...
Replacement leather ear seals for AlphaBass Headset.These serve as a replacement to the original luxurious ear seals for your AlphaBass Headset. Rugged leather ear seals conform better than both ge...
Keep debris out of your MAC-XC with this specially developed plug! During single-rider use, it diverts air pressure to one side for increased flow.
Features:
Hold-tight press fit design
Easy to ...
Compatible with several Midland Handheld Radios. Complete your communications with this hand held radio jumper. Connect your 2-way radio to your wiring harness, intercom, or cabling setup.
Specially developed with a built-in 10K resistor, this cable reduces audio volume from your mobile radio to your intercom system.
Allows better volume control of your incoming radio transmission in...
NASCAR driver communication kit connects to your existing Mot. 2-pin radio. Includes 2 pin radio jumper (compatible with Motorola handheld radios), and mono AlphaBud foam ear bud speakers. (radio n...
Adapt your NASCAR helmet kit to a IMSA car harness.
Note: NASCAR helmet kits are common grounded and may not work with all radios. If you are not sure please call.
The NMO Stick-On features a high quality antenna coaxial cable with a 3M VHB double sided tape mount, and is easily convertible to become two mounts in one!! Mounting Option 1: Adhesive BaseConveni...
Easily add serviceability to your communications system! This DMU Nut Plate provides threaded inserts needed to mount your radio and intercom to any flat dash using our Multi Mount Insert. Simply c...
>> Pre-labeled driver and co-driver intercom cables make cable identification quick and easy to your intercom and listening device.
>> Connect your OFFROAD wired helmet kit or Ultim...
Connect your R1, GMR2, V3, RH-5R, RDH16 or Kenwood 2-Pin radio to an OFFROAD helmet kit or headset with this coil cord.
Plug the 2-pin connector into your radio and the OFFROAD connector into your ...
3' straight extension cord for OFFROAD helmet kits.
Works with all Rugged, PCI Race Radios, Avcomm, RacerX, and other OFFROAD intercoms.
Total Shield RF blocking
Nexus Jack OFFROAD plug
High bend ...
Use this adapter for running headsets while trail riding in a vehicle using OFFROAD intercom cables.
Connects your headset with standard 5-pin connector to female jack of intercom cable. Approximat...
